Temp

 

Pacific Texturing & Laser Engraving

Pacific Texturing & Laser Engraving

"Quality Etched In Steel"

News





Printed June 2000 in

MOLDMAKING TECHNOLOGY MAGAZINE


 If you think of texturing as the paint on a finished car, you can then draw the comparison that the paint job is only as good as the bodywork beneath the paint.  And so, texturing too can be optimized by the quality of the surface to be textured.  (details on  SURFACE PREPARATION.)


   The most prevalent challenge in texturing is the presence of marks on the part created by welds.   Although welding is a necessary evil when it comes to mold making, it remains a texture's nemesis.  However, following proper welding procedures and keeping in mind that the mold will be textured later can eliminate future headaches.  The added cost or loss of time at this point in the mold's construction will lead to better results in the end. 


   Heating the mold before welding, using parent material, and annealing after welding are all valuable processes that should be used to achieve proper welding. When a surface is welded, the difference in metal hardness results in a difference in texture depth in the welded area.  The chemicals used for etching the surface recognize the variable hardness across the welded area and then treat each area differently.  This creates a blemish or flaw in the finished texture.  To worsen the problem, parent materials are not used as the welding material.  Stainless weld is popular because of it flows well and does not leave pits, but for texturing nothing could be worse.  Stainless itself is difficult to texture due to its natural resistance to corrosion.


   Another texturing problem is the EDM process, which creates a scale with uneven hardness across its surface-- where the electrode comes closer to the surface; the hardness is greater and vise versa.  During the process, contact between the electrode and the surface will often result in a mark on the surface, which resembles a weld.  When removing EDM scale, it is common to leave much of it remaining in the corners.  This results in an uneven texture finish.  In polishing there is saying, "polish the corners and the middle will take care of itself."  This holds true with the removal of EDM scale.  When an EDM surface is exposed to the texturing process it tends to begin etching unevenly and many depths and untextured areas are created.  A mixture of copper sulfate and water brushed over the mold's surface will expose remaining EDM scale and clearly identify areas that need more polishing.


   An additional challenge is the common belief that a deep texture will cover or hide scratches or unfinished polishing, when in fact, texturing may highlight scratches and polishing marks.  For this reason, polishing the surface according to the requirements for the texture to be applied is highly recommended.  Many of the textures commonly used in the industry today are capable of hiding surface flaws, but they still require an evenly polished beginning surface.  A 320-emery surface would be sufficient for most of the texturing performed, but communicating with your texturing house before completion is always recommended. 


   Work hardened surfaces are yet another problem for the texturing process which are caused by increased cutter speed or increased tool dwell time in corners or a particular area.  Using different materials in various areas of the same project -- such as H13 inserts in a 7071 block -- also leads to visual differences in the texture finish.

The Finishing Step in the Mold Building Process!

grey_bar.jpgamerican-flag-2a.jpgLaser_Postcard_background.jpg

Home | Laser Engraving/Marking | Mold Texturing | Mold Texture Repair | Mold Polishing | Surface Prep | Texture Plaques | News | About Us | Reach Us


---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Copyright  ©   1989-2010   Pacific Texturing & Laser Engraving   All Rights Reserved

Home
Mold Texturing
Mold Texture Repair
Laser Engraving/Marking
Mold Polishing
Surface Prep
News
About Us
Reach Us